Britax FORWARD FACING CHILD RESTRAINT Instrukcja Użytkownika

byHippo™User GuidePLEASE READINSTRUCTIONSSTORE UNDERCOVER

14 15• Rear-facing installation can be improved by the use of the Versa-Tether. See pages 27–30.6 Align each LATCH strap on the LATCH bar with the “

16 17• Rear-facing installation can be improved by the use of the Versa-Tether. See pages 27–30.• To prevent damage, never extend the lock-off arm b

18 19• The child seat is secure when it cannot be moved more than 1 in. (2.5 cm) front-to-back or side-to-side at the belt path. If the child seat is

20 215 Attach one LATCH hook to its adjacent vehicle LATCH anchor (Fig. B).• The LATCH hook MUST be attached over the LATCH anchor (Fig. C).• Pull

22 23TIP:Turning the back of the child seat toward you can make routing the vehicle belt easier (Fig. C).5 Verify that the vehicle belt is not twiste

24 256 Attach the Versa-Tether hook to the designated tether anchor (if available according to the vehicle owner’s manual) for the chosen seating pos

26 27WARNING! • When using the child seat in forward-facing mode, attach the Versa-Tether only to tether anchors designated by the vehicle manufactur

28 29WARNING! Only use the tether connector strap for rear-facing tether installation when there is NOT a designated vehicle tether anchor.DTether Con

30 31Recline AdjustmentPull the recline handle (Fig. D) then slide the child seat shell into the desired position. Release the recline handle, then ve

32 33Releasing the Harness BucklePress the release button and slide both buckle tongues from the buckle (Fig. E).IMPORTANT: Periodically clean the har

34 358 Gently pull up on the harness straps to tighten lap section of the harness which should fit across the child’s upper thighs.NOTE: The Wedge Po

36 37Refitting the CoverTo refit the cover, reverse the directions on page 36. Make sure that the shoulder straps are not twisted, and are properly th

38 39Cleaning the Harness BuckleIf a child eats and drinks while in the child seat, the harness buckle may need to be periodically checked and cleaned

40This restraint was distributed by Snug Seat®. Snug Seat warrants this product to the original purchaser as follows:LIMITED ONE-YEAR WARRANTY This pr

Double Check Car Seat-to-Vehicle Installation:Check that the LATCH or vehicle seat belts connections to the vehicle are tight and locked.Verify th

Table of ContentsSafety Information ...2 Warnings ...

2 3• Based on crash statistics, the National Highway Traffic Safety Administration (NHTSA) recommends that parents select the back seat as the safest

4 5CertificationThis child seat system conforms to all applicable Federal Motor Vehicle Safety Standards. This child seat is certified for use in moto

6 7Shoulder levelAbove Shoulder LevelBelow Shoulder LevelUprightReclinedForward-Facing Harness HeightBSafety InformationForward-FacingUse forward-faci

8 91651821232425221920261716 Cover17 Serial Number and Manufactured Date Label (under cover)18 Versa-Tether (Top Anchorage Strap) in pouch19 Harne

10 11A wedge positioning system has been provided to assist in achieving a snug fit. Consult a medical professional for proper use. See illustration b

12 13Vehicle Buckle PositionsIf the buckle lies near the incorrect position ( ) when the vehicle seat belt is tightened, try fitting the child seat in